[Floris76]

Hi


My FO keeps showing the same faults again and again after a reset: CMRR RL and CMRR RR, specifically MRR Online Calibration Error (DTC C228E00). 
Unfortunately, I can’t calibrate the CMRR/CMRR because this function is not enabled/activated in my system.

In addition, while driving, the yellow blind-spot warning indicators in the driver display keep lighting up repeatedly. 
This is very distracting and especially bothersome at night during driving. 

Please help me resolve this issue.

[Freesker Support]

Hi there,

before we can provide a precise recommendation, we require a complete DTC report for the entire ADAS system, including:

- FCM (Front Camera Module)

- Hydra

- All 5 MRR units

Based on these DTC reports, we can analyze the situation in detail and proceed in a targeted and structured way.

Please share the reports once available, and we’ll take it from there.

[Floris76]

Hi there,

before we can provide a precise recommendation, we require a complete DTC report for the entire ADAS system, including:

- FCM (Front Camera Module)

- Hydra

- All 5 MRR units

Based on these DTC reports, we can analyze the situation in detail and proceed in a targeted and structured way.

Please share the reports once available, and we’ll take it from there.

Hi,
Here is my DTC report. 
  report 23.01.26.pdf (Size: 112,03 KB / Downloads: 6)   
This is from when I driving for 1 days and covered 60 km. 
In addition, there were also many bus disruptions in other areas.

[Freesker Technical]

I can't detect any active faults in the ADAS system. Is it possible that various control units were removed and then someone tampered with the vehicle?

[Floris76]

No,
In this report it isn’t active at the moment, but you can see which fault code is stored (history). It becomes active intermittently.

[Freesker Technical]

It is important to actively recognize the error; historical errors can also lead to misinterpretation if you do not inspect the car yourself.

[Floris76]

  report (18).pdf (Size: 27,91 KB / Downloads: 4)

[Freesker Support]

Hi there,

Indeed, MRR_RR and MRR_RL lack intrinsic calibration. This can be caused by the general replacement of a new MRR without online calibration or by faulty conditions.

Has there been a change in the positions of these two?

Best regards,
Freesker Team